To Fit And Use Your
Splashguard
1 Raise the mixer head until it locks.
2 Fit the bowl onto the base.
3 Push the splashguard onto the
underside of the mixer head until
fully located. The hinged section should
be positioned as shown.
4 Insert required tool.
5 Lower the mixer head.
O During mixing, ingredients can be
added directly to the bowl via the
hinged section of the splashguard
.
O You do not need to remove the
splashguard to change tools.
6 Remove the splashguard by raising
the mixer head and sliding it down.
Tool Adjustment
K-beater, Whisk, Creaming beater and
folding tool
The tools are set to the correct height
for the bowl supplied in the factory and
should not require adjustment.
However, if you wish to adjust the tool
use a suitable 15mm spanner:
Then follow the instructions below:
1 Unplug the machine.
2 Raise the mixer head and insert the
whisk or beater.
3 Lower the mixer head. If the
clearance needs to be adjusted,
raise the mixer head and remove
the tool. Ideally the whisk, K-beater
and folding tool should be almost
touching the bottom of the bowl .
Creaming beater
O Ideally it should be in contact with
the bowl surface so that it gently
wipes the bowl during mixing (4.
4 Using a suitable spanner loosen the
nut sufficiently to allow adjustment
of the shaft or (5. To lower the
tool closer to the bottom of the
bowl, turn the shaft anti-clockwise.
To raise the tool away from the
bottom of the bowl turn the shaft
clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower
the mixer head.
(Check its position see points
above).
7 Repeat the above steps as
necessary until the tool is set
correctly. Once this is acheived
tighten the nut securely.
Note: Spanner shown is for illustration
purpose only.
Dough Tool
This tool is set at the factory and should
require no adjustment.
Creaming Beater
O The creaming beater is designed for
creaming and mixing soft ingredients.
Do not use with heavy recipes such
as dough or hard ingredients, for
example those containing fruit stones,
bones or shells.
Fitting the Wiper Blade
O The wiper blade is supplied
already fitted and should always
be removed for cleaning (6.
1 Carefully fit the flexible wiper
blade onto the tool by locating
the base of the wiper blade
into the slot (1 then fit one side
into the groove before gently
hooking the end in place (2.
Repeat with the other side (3.
10