5019 318 33114
AKR 683 - AKR 633
D F NL E
GB
P I GR
1.
Control panel.
2.
Extractor grilles with internal grease
filters - External grease filters
(models DNHV5460 and DNV5460 only).
3.
Lighting unit.
4.
Pull-out steam deflector (switches the hood on/off
if an extraction speed has already been selected).
Replacing bulbs:
1.
Disconnect the electrical power supply.
2.
Pull out the steam deflector.
3.
Open the back grille (
a - fig. 1
).
4.
Remove the burnt-out bulb.
Replace using 40 W max E14 bulbs only.
5.
Refit the extractor grille or lighting unit.
Removing and renewing or cleaning the grease
filter:
1.
Disconnect the electrical power supply.
2.
Pull out the steam deflector.
3.
Remove the extractor grilles (
c - fig. 1 / d - fig. 2
).
4.
Release the grease filter.
5.
Remove the dirty grease filter (
e - fig. 2
).
6.
After the grease filter has been renewed or
cleaned (depending on model), remount in
reverse order, making sure the entire extraction
surface is covered.
Fitting or renewing the carbon filter:
1.
Disconnect the electrical power supply.
2.
Pull out the steam deflector.
3.
Remove the extractor grilles (
c - fig. 1 / d - fig. 2
).
4.
If the carbon filter (
f - fig. 3
) is already fitted and
needs renewing, turn anti-clockwise and pull the
filter out downwards.
5.
If the carbon filter (
f - fig. 3
) is not already fitted,
mount the filter over the protection grille and turn
clockwise.
6.
Refit the extractor grille.
CONTROL PANEL
Light switch.
The switch has two positions
(lights OFF - lights ON).
To switch on the lights: move the switch to the
right.
Motor switch.
The extraction speed switch has 3 settings,
depending on the amount of steam and fumes.
To increase the extraction speed: move the
switch to the right.