15
EN 8.2 Treatment steps
1. Make sure your skin is clean, dry and free from powder, cream
or gel.
2. Make sure the rubber cap 2, filter 3 and treatment tip 1
are firmly in place on the main unit 4.
We recommend that you start with the fine treatment tip (see
section “Attaching and replacing the treatment tips”).
3. Connect the cable of the AC/DC adapter 7 to the adapter
socket 6.
4. Connect the AC/DC adapter to a mains socket.
5. Press the control button ( ) 5 to turn the product on. The
product is ready for use in the low suction mode.
6. Apply the treatment tip firmly to your skin so that you feel
the suction. Treat each area as recommended in the section
“Treatment areas”.
7. If necessary, press the control button ( ) again to change from
low to high suction mode.
8. When done, press the control button ( ) once or twice to
turn the product o (depending on the current suction mode).
9. Disconnect the AC/DC adapter from the adapter socket and
mains socket.
Avoid direct sunlight and apply SPF 30 or higher
immediately after a treatment. You may also wish to
apply a facial mask, or a day or night cream.
9 Cleaning and maintenance
9.1 Cleaning the main unit and treatment tips
1. Disconnect the product from the mains socket.
2. Wipe the main unit 4 with a damp cloth. Then wipe it
completely dry with a dry cloth.
3. To clean the treatment tips 1, first remove them from the
main unit. Wash the treatment tips with soap and water, then
dry them thoroughly.
It is recommended to replace the treatment tips every
6months, or earlier if the abrasive ends of the tips are damaged.