Yamaha C-80 El kitabı

Yamaha
Marka
Yamaha
Modeli
C-80
Kategori
Ses amplifikatörleri
Tip
El kitabı

Bu kılavuz aynı zamanda aşağıdakiler için de uygundur:

NS-C80
Natural Sound
Center Speaker System
Thank you for selecting this Yamaha NS-C80 speaker system.
This model is designed mainly to be used as a center speaker system.
PRECAUTIONS
Read these precautions carefully before operating
your speaker.
• When using an amplifier with a rated output power
higher than the music input of the speaker, care
should be taken never to exceed the speaker’s
music input.
• Do not attempt to clean the speaker with chemical
solvents as this might damage the finish. To clean,
wipe with a dry, soft cloth.
• To prevent the enclosure from warping or
discoloring, do not place the speaker where it will
be exposed to direct sunlight or excessive humidity.
• Do not place the speaker where it is liable to be
knocked over or struck by falling objects. Stable
placement will also ensure better sound
performance.
• Placing the speaker on the same shelf or rack as
the turntable can result in feedback.
• Anytime you note distortion, reduce the volume
control on your power amplifier/receiver to a lower
setting. Never allow your power amplifier to be
driven into “clipping”.
• Secure placing is the owner’s responsibility.
YAMAHA shall not be liable to any accident
caused by an improper placing of the speaker.
Notes
• The speaker should be placed so that it is
stabilized (with its wide surface down).
Do not place the speaker on either end or with its
narrow surface down.
• Though this speaker is a magnetic shielding
type, there may be an influence on TV picture
according to the type of TV or the placement of
the speaker. In such a case, place the speaker
apart from the TV so that there is no influence on
TV picture.
PLACING THE SPEAKER
NS-C80
TV set
CONNECTION TO
YOUR AMPLIFIER
BEFORE MAKING CONNECTIONS, MAKE SURE
THAT THE AMPLIFIER IS SWITCHED OFF.
m CONNECTIONS
• Connect the push-type input terminals at the rear of
the speaker to the speaker output terminals of your
amplifier with speaker cables.
• Make sure not to reverse the polarity (+, –). If
connected with reversed polarity, the sound will be
unnatural and lack bass.
Procedures:
1 Press the tab on the terminal down, as shown in
the figure.
2 Insert the bare wire end properly into the terminal
hole. [Remove approx. 5 mm (1/4”) insulation
from the speaker cable.]
3 Remove your finger from the tab to allow it to lock
snugly on the cable’s wire end.
4 Test the security of the connection by tugging
lightly on the cable at the terminal.
Note
Do not let the bare speaker wires touch each other
as this could damage the speaker and/or the
amplifier.
SPECIFICATIONS
Type ....................................Acoustic-suspension type
Magnetic-shielding type (EIAJ)
Speaker Unit ............10 cm cone woofer (JA1065) x 2
2.5 cm balanced dome tweeter (JA05R4) x 1
Crossover ..........................................6 kHz (6 dB/oct)
Input Terminal .............................................Push-type
Nominal Impedance .........................................6 ohms
Frequency Response ..........................80 Hz – 20 kHz
Nominal Input Power ............................................40W
Music Input Power ................................................80W
Sensitivity ...................................................90 dB/w/m
Dimensions (WxHxD)...................445 x 135 x 166 mm
(17-
1
/2” x 5-
5
/16” x 6-
9
/16”)
Weight ...........................................3.3 kg (7 lbs. 4 oz.)
* Specifications subject to change without notice due
to product improvements.
* Care should be taken not to exceed the input power
values noted above.
VQ04130-0 BWWR, BB Printed in Japan
Press tab
NS-C80
Center speaker
output terminals
of the amplifier
  • Page 1 1
  • Page 2 2

Yamaha C-80 El kitabı

Yamaha
Marka
Yamaha
Modeli
C-80
Kategori
Ses amplifikatörleri
Tip
El kitabı
Bu kılavuz aynı zamanda aşağıdakiler için de uygundur:
PDF''yi indir
rapor

diğer dillerde

İlgili makaleler