User Guide

IP54 Urban Design Angular Solar Pathway

Light with PIR Motion Sensor

400lm Ultra Bright • 3 Light Modes • Energy Efficient LED

SolarTrail-2

English

Introduction

The SolarTrail-2 is a superior quality solar LED wall light that offers exceptional performance in a

contemporary design. It has a minimal feel and is perfect for year-round use, as it has 3

• User Guide

Specifications

• Battery Capacity: 2000mAh

• Battery Type: Li-ion

• Solar Panel Output: 5.5V/418mA

• LED Brightness: 400lm

• PIR Motion Sensor Range: ≤ 6m

• Charging Time: 6 Hours

• Usage Time:

o Continuous Usage: 2-3 Hours

1. Do not disassemble the product or attempt to fix it.

2. If applicable, use an original charging cable provided to charge the product.

3. Do not crush, puncture, dispose of in fire, short the contacts or expose the product

to water or other liquids.

4. Avoid drops, bumps, abrasions and impacts.

5. If there is any reason to believe that there is damage to the product, discontinue

use immediately.

6. If you find that the product is too hot, is emitting an odour, or is deformed,

punctured or exhibits any suspicious or abnormal behaviour, discontinue use

immediately and contact our customer service.

a wide area.

Long-Lasting & Energy-Saving: The SolarTrail-2 can charge in only 6 hours and last for

3 hours long.

Easy-to-Install: Super easy to setup and install, add the needed light source for the

outside of your home quickly without using any electrical wiring. It will work

anywhere there is direct sunshine.

Water-Resistant: This solar LED light is water-resistant and durable with hard

fire-proof plastic that can withstand years of use.

4

1. Please use the card to measure hole position correctly and drill 3 holes.

2. Fix 3 expansion plugs into the holes.

3. Fix 3 screws into the expansion plugs with a spare space.

4. Insert the notch to the lower screw and fasten the whole lamp well.

5. Press the back button to adjust to the demanded working mode.

Mode A: Automatically turns on at dusk and remains 20% bright for up to 5 hours

before turning itself off

sunshine.

• Please note the lighting time depends on sunshine duration and weather.

• The lamp will light up automatically at dusk.

• Built-in intelligent IC overcharge, over-discharge, and over-voltage protection.

SolarTrail-2

Aspecto & Descripción de la Interfaz

1. Por favor, utilice la tarjeta para medir correctamente la posición de los agujeros y

hasta 5 horas antes de apagarse.

Modo B: Activa automáticamente el brillo completo (400lm) cuando se detecta

movimiento en el área de trabajo, y luego activa el brillo del 3% en 20 segundos

cuando no se detecta movimiento.

Modo C: Automáticamente se enciende hasta alcanzar el brillo máximo (400 lm)

cuando se detecta movimiento en el área de trabajo y se desactiva en 30 segundos

cuando no se detecta movimiento.

• Esta es una lámpara que funciona con energía solar; por favor, instálela en un lugar

donde pueda recibir suficiente luz solar.

• Tenga en cuenta que el tiempo de iluminación depende de la duración del sol y del