14
en Operation
W Risk of electric shock!
Only immerse the blender foot into the food
as far as the marking Í or there will be
a risk of electric shock!
6. To start processing with the preselected
speed, press the On button Ã.
7. To start processing with the highest
speed, press the Turbo button Ã.
8. Process the food with the blender foot.
9. Release the button when the desired
consistency is reached. Wait until
the drive comes to a standstill.
Disconnect the mains plug.
10. Hold down both release buttons and
remove the blender foot.
11. Clean all parts immediately after use.
X “Care and daily cleaning” see
page 14
Notes:
– To prevent splashing, fully immerse the
blender blade in the ingredients before
switching on the appliance.
– With liquid foodstuffs, immerse the
blender foot and hold it at a slight angle
for better blending results and to prevent
the ingredients from sticking to the
bottom of the receptacle.
Care and daily cleaning
The appliance and the tools used must be
thoroughly cleaned after each use.
Caution!
– Do not use any cleaning agents
containing alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
– Do not wedge plastic parts in the
dishwasher as they could become
permanently deformed.
Please note:
– To make it easier to clean the blender
foot, after use place it in a receptacle
containing clean water and briefly press
the Turbo button  several times.
Caution!
Never press the On button à and the
Turbo button  at the same time.
Release buttons
To remove the blender foot or other
accessories, press both release buttons
simultaneously.
Stainless steel blender foot
The blender foot is suitable for cutting
and mixing mayonnaise, sauces, blended
drinks, baby food, cooked fruit and cooked
vegetables, and for pureeing soups.
Accessories
If an accessory is not included with the
hand blender, it can be ordered from
customer service:
Accessories Order no.
Universal cutter L 12027759
Universal cutter XL 12027760
Whisk 12027761
“ProPuree” masher attachment 12027762
Operation
Caution!
– The blender foot must be securely
connected to the base unit. The blender
foot must not wobble or fall off.
– Solid foods such as apples, potatoes
and meat always must be cut up and
cooked until soft before processing. Use
the universal cutter for cutting/chopping
raw food (onions, garlic, herbs, etc.).
X Image sequence B
1. Place the prepared food in the blender
jug or another suitable receptacle or
process in the pan used for cooking.
2. Completely unwind the power cord.
3. Hold the base unit securely, fit the
blender foot onto the base unit and
press until it clicks into position.
4. Set the desired speed with the speed
control dial. Plug the mains plug into the
mains.
5. Hold the receptacle with one hand and
immerse the blender foot.