Dell PowerVault DL2100 Hızlı başlangıç Kılavuzu

Dell™ PowerVault™

DL2100 Systems

Getting Started

With Your System

Začínáme se systémem

Guide de mise en route

Handbuch zum Einstieg

Τα πρώτα βήματα με το σύστημά σας

Rozpoczęcie pracy z komputerem

Приступая к работе с системой

Procedimientos iniciales con el sistema

Sistem Başlangıç Kılavuzu

Dell™ PowerVault™

DL2100 Systems

Getting Started

With Your System

Regulatory Model E02S

Notes, Cautions, and Warnings

NOTE: A NOTE indicates important information that helps you make better use

of your computer.

CAUTION: A CAUTION indicates potential damage to hardware or loss of data if

instructions are not followed.

WARNING: A WARNING indicates a potential for property damage,

personal injury, or death.

____________________

Information in this document is subject to change without notice.

Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc.

is strictly forbidden.

Dell, the DELL logo, and PowerVault are trademarks of Dell Inc.; Intel and Xeon are registered

trademarks of Intel Corporation in the U.S. and other countries.

Other trademarks and trade names may be used in this document to refer to either the entities claiming

the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and

trade names other than its own.

Regulatory Model E02S

April 2010 P/N G59TD Rev. A01

Getting Started With Your System 3

Installation and Configuration

WARNING: Before performing the following procedure, review the safety

instructions that came with the system.

Unpacking the System

Unpack your system and identify each item.

Installing the Rails and System in a Rack

Assemble the rails and install the system in the rack following the safety

instructions and the rack installation instructions provided with your system.

4 Getting Started With Your System

Optional — Connecting the Keyboard, Video, and Mouse

Connect the keyboard, mouse, and monitor (optional).

The connectors on the back of your system have icons indicating which cable

to plug into each connector. Be sure to tighten the screws (if any) on the

monitor's cable connector.

Connecting the Ethernet Cable

Connect an Ethernet cable to one of the Ethernet connectors at the back

of the system.

Getting Started With Your System 5

Connecting the Power Cable(s)

Connect the system’s power cable(s) to the system.

Securing the Power Cable(s)

Bend the system power cable(s) into a loop as shown in the illustration and

secure the cable(s) to the bracket using the provided strap.

Plug the other end of the power cable(s) into a grounded electrical outlet

or a separate power source such as an uninterruptible power supply (UPS) or

a power distribution unit (PDU).

6 Getting Started With Your System

Turning on the System

Press the power button on the system and the monitor. The power indicator

should light.

Installing the Optional Bezel

Install the bezel (optional).

Getting Started With Your System 7

Other Information You May Need

WARNING: See the safety and regulatory information that shipped with

your system. Warranty information may be included within this document or

as a separate document.

• The rack documentation included with your rack solution describes how to

install your system into a rack.

• The

Hardware Owner’s Manual

provides information about system

features and describes how to troubleshoot the system and install or

replace system components. This document is available online at

support.dell.com/manuals.

• Any media that ships with your system that provides documentation and

tools for configuring and managing your system, including those

pertaining to the operating system, system management software,

system updates, and system components that you purchased

with your system.

NOTE: Always check for updates on support.dell.com/manuals and read the

updates first because they often supersede information in other documents.

Obtaining Technical Assistance

If you do not understand a procedure in this guide or if the system does not

perform as expected, see your Hardware Owner’s Manual. Dell

™

offers

comprehensive hardware training and certification. See www.dell.com/training

for more information. This service may not be offered in all locations.

8 Getting Started With Your System

NOM Information (Mexico Only)

The following information is provided on the device described in this

document in compliance with the requirements of the official Mexican

standards (NOM):

Technical Specifications

Importer:

Model number: E02S

Supply voltage: 100–240 VAC

Frequency: 50/60 Hz

Current consumption: 7.0–3.5A

Processor

Processor type One or two quad-core Intel

®

Xeon

®

processors

Expansion Bus

Bus type PCI Express Generation 2

Expansion slots using

riser cards:

Riser 1 (Center Riser)

One full-height, 9.5-inch length, x4 link (slot 1)

NOTE: This slot can be upgraded to 12.2 inches.

One low-profile, 9.5-inch length, x4 link (slot 2)

Riser 2 (Left Riser)

Two full-height, 9.5-inch length, x8 link (slot 3 and 4)

or

One full-height, 9.5-inch length, x16 link (slot 3)

NOTE: Support for up to 25 W is available only on the first

two cards installed in the system; any additional cards

installed in the system must be 15 W or under.

Getting Started With Your System 9

Memory

Architecture 800, 1066, or 1333 MHz DDR3 registered or unbuffered

Error Correcting Code (ECC) DIMMs. Support for

Advanced ECC or Memory Optimized operation.

Memory module

sockets

Eighteen 240-pin

Memory module

capacities

1 GB and 2 GB UDIMMs, and 2 GB, 4 GB,

or 8 GB RDIMMs

(single, dual, or quad-rank dependent on capacity)

Minimum RAM 1 GB with a single processor (1 DIMM per processor)

Maximum RAM 96 GB (with quad-rank 8 GB RDIMM),

144 GB (with dual-rank 8 GB RDIMM),

or 24 GB (with 2 GB UDIMMs)

Drives

Hard drives Up to six 3.5-inch, internal, hot-swappable SAS or

SATA hard drives

Diskette drive Optional external USB 1.44 MB drive

Optical drive One internal slimline SATA DVD-ROM or

DVD+RW drive

Optional external USB DVD

NOTE: DVD devices are data only.

Flash drive Optional internal USB

Optional internal Secure Digital (SD) memory card

Optional external SD memory card

Connectors

Back

NIC

Four RJ-45 10/100/1000 Mbps Ethernet

Serial

9-pin, DTE, 16550-compatible

USB

Two 4-pin, USB 2.0-compliant

Video

15-pin VGA

Optional external

VFlash card

One flash memory card slot on the back panel

10 Getting Started With Your System

Front

Video

15-pin VGA

USB

Two 4-pin, USB 2.0-compliant

Internal

USB

One 4-pin, USB 2.0-compliant

Optional internal

SD module

One internal flash memory card slot

Video

Video type Integrated Matrox G200

Video memory 8 MB shared

Power

AC Power Supply (per power supply)

Wa tt ag e

870 W (High Output)

570 W /200840 KB (Energy Smart)

Voltage

90–264 VAC, autoranging, 47-63 Hz

Heat dissipation

2968.6 BTU/hr maximum (High Output)

1944.9 BTU/hr maximum (Energy Smart)

Maximum inrush

current

Under typical line conditions and over the entire system

ambient operating range, the inrush current may

reach 55 A per power supply for 10 ms or less.

Batteries

System battery

CR 2032 3.0-V lithium coin cell

RAID battery

(optional)

3.7-V lithium ion battery pack

Connectors (continued)

Getting Started With Your System 11

Physical

Height 8.64 cm (3.4 in)

Width 48.24 cm (18.99 in) with rack latches

44.31 cm (17.4 in) without rack latches

Depth 72.06 cm(28.4 in) with power supplies and bezel

68.07 cm(26.8) without power supplies and bezel

Weight (maximum

configuration)

26.1 kg (57.54 lb)

Weight (empty) 17.7 kg (39 lb)

Environmental

NOTE: For additional information about environmental measurements for specific

system configurations, see www.dell.com/environmental_datasheets

Temperature

Operating

10° to 35°C (50° to 95°F) with a maximum temperature

gradation of 10°C per hour

NOTE: For altitudes above 2950 feet, the maximum operating

temperature is derated 1°F/550 ft.

Storage

–40° to 65°C (–40° to 149°F) with a maximum temperature

gradation of 20°C per hour

Relative humidity

Operating

20% to 80% (non-condensing) with a maximum humidity

gradation of 10% per hour

Storage

5% to 95% (non-condensing) with a maximum humidity

gradation of 10% per hour

Maximum vibration

Operating

0.26 Gms from 5–350 Hz for 5 minutes in operational

orientations

Storage

1.54 Gms from 10–250 Hz for 10 minutes in all orientations

12 Getting Started With Your System

Maximum shock

Operating

Half sine shock in all operational orientations of 31 G plus

or minus 5% with a pulse duration of 2.6 ms plus or

minus 10%

Storage

Half sine shock on all six sides of 71 G plus or minus 5%

with a pulse duration of 2 ms plus or minus 10%

Square wave shock on all six sides of 27 G with a velocity

change at 235 in/sec or greater

Altitude

Operating

–16 to 3048 m (–50 to 10,000 ft)

NOTE: For altitudes above 2950 feet, the maximum operating

temperature is derated 1°F/550 ft.

Storage

–16 to 10,600 m (–50 to 35,000 ft)

Environmental (continued)

Systémy

Dell™

PowerVault™ DL2100

Začínáme se systémem

Regulační model E02S

Poznámky a upozornění

POZNÁMKA:

POZNÁMKA označuje důležité informace, které pomáhají lepšímu využití

počítače.

UPOZORNĚNÍ: UPOZORNĚNÍ označuje nebezpečí poškození hardwaru nebo

ztráty dat v případě nedodržení pokynů.

VAROVÁNÍ: VAROVÁNÍ upozorňuje na potenciální nebezpečí poškození majetku,

úrazu nebo smrti.

____________________

Informace obsažené v tomto dokumentu podléhají změnám bez předchozího upozornění.

Jakákoli reprodukce těchto materiálů bez písemného povolení společnosti Dell Inc. je přísně zakázána.

Dell, logo DELL a PowerVault jsou ochranné známky společnosti Dell Inc.; Intel a Xeon jsou

registrované ochranné známky společnosti Intel Corporation ve Spojených státech amerických a

dalších zemích.

V tomto dokumentu mohou být použity další ochranné známky a obchodní názvy s odkazem na

společnosti vlastnící tyto známky a názvy nebo na jejich produkty. Společnost Dell Inc. nemá

vlastnické zájmy vůči ochranným známkám a obchodním názvům jiným než svým vlastním.

Regulační model E02S

Duben 2010 Č. dílu G59TD Rev. A01

Začínáme se systémem

15

Instalace a konfigurace

VAROVÁNÍ: Před provedením následujícího postupu si prostudujte bezpečnostní

pokyny dodané se systémem.

Rozbalení systému

Rozbalte systém a identifikujte jeho jednotlivé součásti.

Instalace kolejniček a systému do stojanu

Sestavte kolejničky a nainstalujte systém do stojanu podle bezpečnostních

pokynů a pokynů k instalaci do stojanu dodaných se systémem.

16

Začínáme se systémem

Volitelné — připojení klávesnice, videa a myši

Připojte klávesnici, myš a monitor (volitelné).

Konektory na zadní straně systému mají ikony znázorňující, který kabel se má

připojit ke kterému konektoru. Zajistěte, aby šrouby na konektoru kabelu

monitoru byly dobře dotaženy (je-li jimi konektor vybaven).

Připojení Ethernetového kabelu

K jednomu z konektorů pro Ethernet v zadní části systému připojte

Ethernetový kabel.

Začínáme se systémem

17

Připojení napájecích kabelů

Připojte napájecí kabel(y) k systému.

Zajištění napájecích kabelů

Ohněte napájecí kabel do smyčky, jak je znázorněno na obrázku, a připevněte

jej dodanou páskou k držáku.

Poté zasuňte druhý konec kabelu do uzemněné elektrické zásuvky nebo jej

připojte k samostatnému zdroji napájení, například ke zdroji nepřerušitelného

napájení (UPS) nebo k jednotce rozvaděče (PDU).

18

Začínáme se systémem

Zapnutí systému

Stiskněte vypínač na systému a na monitoru. Měl by se rozsvítit indikátor

napájení.

Instalace volitelného čelního krytu

Nainstalujte čelní kryt (volitelný).

Sayfa yükleniyor...

Dell PowerVault DL2100 Hızlı başlangıç Kılavuzu

Dell PowerVault DL2100 Hızlı başlangıç Kılavuzu

diğer dillerde

İlgili makaleler

Dell PowerVault DL2100 Hızlı başlangıç ​​Kılavuzu

Dell PowerVault DL2100 Hızlı başlangıç ​​Kılavuzu

diğer dillerde

İlgili makaleler

Dell PowerVault DL2100 Hızlı başlangıç Kılavuzu

Dell PowerVault DL2100 Hızlı başlangıç Kılavuzu