Whirlpool AKR 993 IX Program Chart

Whirlpool
Marka
Whirlpool
Modeli
AKR 993 IX
Kategori
Ocak davlumbazları
Tip
Program Chart
AKR 993
5019 100 75156
INSTALLATIONSANGABEN
Mindestabstand zur Kochfläche:
60 cm (Elektroplatten), 75 cm (Gas-, Öl- oder Kohlekochplatten).
Bei der Installation die Numerierung befolgen (1
Ö
2
Ö
3
Ö
.....).
Das Gerät erst nach erfolgter Installation an die Stromversorgung anschließen.
Sollte eine unzugängliche Steckdose verwendet werden, ist ein normgerechter
doppelpoliger Schalter mit einem Mindestabstand der geöffneten Kontakte von 3 mm in
einer leicht zugänglichen Position anzubringen.
INSTALLATION SHEET
Minimum height above cooker:
60cm (electric cookers), 75cm (gas, gas oil or coal cookers).
To install follow points (1
Ö
2
Ö
3
Ö
.....).
Do not connect the appliance to the electrical power supply until installation is
completed.
If the plug is not easily accessible once inserted into the socket, a two-pole switch with
minimum break distance between contacts of 3 mm must be fitted at an easily
accessible point.
FICHE D’INSTALLATION
Distance minimale par rapport à la cuisinière :
60 cm (cuisinière électrique), 75 cm (cuisinière à gaz, mazout ou charbon).
Pour le montage, suivez la numérotation (1
Ö
2
Ö
3
Ö
.....).
Ne branchez pas l’appareil tant que l’installation n’est pas terminée.
S’il s’avère difficile d’accéder à la prise de courant une fois qu’elle a été insérée dans la
fiche, installez un interrupteur bipolaire conforme facilement accessible ayant une
ouverture minimale de 3 mm entre les contacts.
INSTALLATIEKAART
Minimum afstand van het kooktoestel:
60 cm (elektrische kooktoestellen), 75 cm (kooktoestellen op gas, olie of kolen).
Volg voor de montage de nummering (1
Ö
2
Ö
3
Ö
.....).
Geef het apparaat geen stroom totdat de installatie geheel voltooid is.
Als de stekker, wanneer hij in het stopcontact gestoken is, zich niet op een toegankelijk
punt bevindt, moet hoe dan ook een genormaliseerde tweepolige schakelaar worden
gemonteerd met een afstand tussen de contacten van minstens 3 mm, die goed
toegankelijk is.
FICHA DE INSTALACIÓN
Distancia mínima de los quemadores:
60 cm (quemadores eléctricos), 75 cm (quemadores a gas, gasóleo o carbón).
Para el montaje, seguir la numeración (1
Ö
2
Ö
3
Ö
.....).
No enchufar el aparato hasta que su instalación no esté terminada.
Si la clavija no se encuentra en un punto accesible una vez enchufada, se deberá aplicar
un interruptor bipolar según las normas con una distancia de abertura entre los
contactos no inferior a 3 mm, que naturalmente deberá ser accesible.
FICHA DE INSTALAÇÃO
Distância mínima dos fogões:
60cm (fogões eléctricos), 75cm (fogões a gás, óleo ou carbono).
Para montar siga a numeração (1
Ö
2
Ö
3
Ö
.....).
Não ligue o aparelho à corrente eléctrica até a instalação estar concluída.
Inserida a ficha na tomada, caso não seja fácil o acesso à mesma, deve ser aplicado um
interruptor bipolar, com distância mínima entre os contactos de 3 mm, num ponto de
fácil acesso.
D
GB
F
NL
E
P
AKR 993
5019 100 75156
SCHEDA INSTALLAZIONE
Distanza minima dai fuochi:
60cm (fuochi elettrici), 75cm (fuochi a gas, gasolio o carbone).
Per il montaggio seguire la numerazione (1
Ö
2
Ö
3
Ö
.....).
Non dare corrente all’apparecchio finché l’installazione non è totalmente completata.
Se la spina, una volta inserita nella presa, non si trova in un punto accessibile, si dovrà
comunque applicare un interruttore bipolare a norme con una distanza dei contatti in
apertura non inferiore a 3 mm, chiaramente accessibile.
ùüùü+ùùùþ
ü$12.)12.1.)2"0120"
FP02!"0120"FP0120".0! #02!0. #0! # 
+.22  21.  #1202.!1
Ö
Ö
Ö

2! 3 / 2020002!)!0*.21#10#!2  !&12"
0.212.1"
ù2 3"0221*/0112!./0!102.101000* !)1.1
!0.2  020/ )"/.)2"102&. 1+00$12
.)12.1. .2 "02.*2&0.3+PP100* .! 1011
I
GR
AKR 993
5019 100 75156
Deflektor
F
NUR in der UMLUFTVERSION!
Deflector
F
for FILTER VERSION ONLY!
Déflecteur
F
UNIQUEMENT pour VERSION
RECYCLAGE!
Deflector
F
UITSLUITEND voor VERSIE MET
FILTER!
Deflector
F
¡SÓLO PARA EL MODELO
FILTRADOR!
Deflector
F
APENAS para a VERSÃO COM
FILTRO!
Deflettore
F
SOLO per VERSIONE FILTRANTE!
ü2! ."
)
.üü
-ÿùÿù
14. Stromanschluss vornehmen
14. prepare electrical
connections
14. préparez le branchement
électrique
14. voorbereiding voor
elektrische aansluiting
14. preparar la conexión
eléctrica
14. preparar a ligação eléctrica
14. preparare il collegamento
elettrico
! 02 1202
02!1*/01
Nicht mitgeliefert
Not provided
Non fourni
Niet bijgeleverd
No suministrado
Não fornecido
Non fornito
û0.!$02.
AKR 993
5019 100 75156
Cleaning the grease filter:
Wash the grease filter at least once a month, or
whenever the grease filter saturation indicator
flashes (Extraction speed indicator
2
).
1.
Unplug the appliance or disconnect the mains
power supply.
2.
Remove the grease filters: push the handles
back (
a
), and then downwards (
b
).
3.
After cleaning the grease filter refit in reverse
order, making sure the entire extraction
surface is covered.
Replacing bulbs
1.
Unplug the appliance or disconnect the mains
power supply.
2.
Using a screwdriver or any other suitable tool,
prise off the lamp cover (
c
).
3.
Remove the burnt-out bulb.
Use 20W max halogen bulbs only, making
sure not to touch them with your hand.
4.
Replace the lamp cover so that it clicks into
position.
Fitting or renewing the carbon filter:
1.
Unplug the appliance or disconnect the mains
power supply.
2.
Remove the grease filters (
a, b
).
3.
Fit the carbon filter, fixing it with the two
screws supplied (
d
).
4.
If the carbon filter needs renewing, remove
the old filter and fit a new one.
Change the carbon filter at least once a year
and, in any event, every time the carbon filter
saturation indicator flashes (Extraction power
indicator
3
).
5.
Refit the grease filter.
Reset filter indicator: press the
OFF
button
until
LED 2
and/or
LED 3
stop flashing.
CONTROL PANEL
1.
Extraction
OFF
button.
2.
Extraction
ON
and speed increase button -
1
Ö
3
Ö
1......
3.
Extraction speed indicator
1
4.
Extraction speed indicator
2
and grease filter
saturation indicator (when flashing).
5.
Extraction speed
3
and carbon filter
saturation indicator (when flashing), a
function which is normally deactivated. In
order to activate it press button
1
, then
buttons
2
and
7
at the same time, until the
carbon filter saturation indicator starts
flashing. To deactivate the function repeat the
operation until the carbon filter saturation
indicator stops flashing.
6.
Intensive extraction speed indicator.
7.
Timed intensive speed button: the hood
operates at this speed for 5 minutes and then
returns to the previous settings. This function
can be cancelled by pressing button
1
or
2
.
8.
Light
OFF
button.
9.
Light
ON
button.
PRODUCT DESCRIPTION SHEET
1.
Control panel
2.
Grease filters
3.
Grease filter handles
4.
Halogen bulb
5.
Telescopic flue
F NL E PGBD GRI
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Whirlpool AKR 993 IX Program Chart

Whirlpool
Marka
Whirlpool
Modeli
AKR 993 IX
Kategori
Ocak davlumbazları
Tip
Program Chart
PDF''yi indir
rapor

diğer dillerde

İlgili makaleler

Diğer belgeler