5019 100 75162
AKR 901 IX-2
1. Control panel.
2. Grease filters
(supplied ready for installation).
3. Grease filter handles.
4. Lighting unit
5. Telescopic flue.
Replacing bulbs - Fig. 1
1. Unplug the appliance or disconnect the mains
power supply.
2. Remove screw (a) and detach the lighting
unit.
3. Remove the burnt-out bulb. Replace with
11W max (PL) bulbs only.
4. Remount the lighting unit and secure with
screw (a).
Cleaning the grease filter
Wash the grease filter once a month, or
whenever the grease filter saturation indicator
flashes
(Extraction speed indicator 2).
1. Unplug the appliance or disconnect the mains
power supply.
2. Remove the grease filters.
- pull the grease filter handles downwards
and release from the rear slot
(b, c - Fig. 2).
3. After cleaning the grease filter refit in reverse
order, making sure the entire extraction
surface is covered.
Fitting or renewing the carbon filter:
1. Unplug the appliance or disconnect the mains
power supply.
2. Remove the grease filters.
3. Fit the carbon filter by fixing it with the two
screws supplied (d - Fig. 3).
4. If the carbon filter needs renewing, remove
the old filter and fit a new one.
Change the carbon filter once a year and, in
any event, every time the carbon filter
saturation indicator flashes (Extraction speed
indicator 3).
5. Refit the grease filters.
THE CONTROL PANEL
1. Extraction OFF button.
2. Extraction ON speed increase button
- 1
Ö
3
Ö
1......
3. Extraction speed indicator 1.
4. Extraction speed indicator 2 and grease filter
saturation indicator (when flashing).
5. Extraction speed indicator 3 and carbon filter
saturation indicator (when flashing):
This is
normally deactivated. In order to activate it
press button 1, then buttons 2 and 7 at the
same time until the carbon filter saturation
indicator starts flashing. To deactivate the
function repeat the operation until the carbon
filter saturation indicator stops flashing
.
6. Intensive extraction speed indicator.
7. Timed intensive speed button: the hood
operates at this speed for 5 minutes and then
returns to the previous settings.
This function can be cancelled by pressing
button 1 or 2.
8. Light OFF button.
9. Light ON button.
Reset filter indicator: Press the extraction OFF
button until LED 2 and/or LED 3 stop flashing.
FIG. 1
FIG. 2
FIG. 3
F NL E PGBD IGR
PRODUCT SHEET
75162.fm5 Page 6 Monday, April 10, 2000 1:36 PM