Whirlpool AKR 605 IX Program Chart

Marka: Whirlpool

Modeli: AKR 605 IX

Kategori: Ocak davlumbazları

Tip: Program Chart

5019 318 33231

MONTAJ SAYFASI

Ocağın üstünde bulunan kaplar ile davlumbazın en alt parçası arasında, elektrikli

ocaklarda en az 65 cm, gaz veya kombi ocaklarda en az 75 cm mesafe bırakılmalıdır.

Gazlı ocakların montaj talimatlarında daha fazla mesafe bırakılması isteniyorsa, bu

durum dikkate alınmalıdır.

Montaj ve kullanımla ilgili not: Montaj için yetkili bir teknisyene başvurun.

Davlumbazı monte etmeden veya kullanmadan önce, bu kılavuzu dikkatle

okuyun; şekilleri ilk sayfalarda bulabilirsiniz.

Cihazı monte ederken, (1Ö2Ö3Ö.....) adımlarını ve ilgili talimatları takip edin.

Havalandırma borusu ve sabitleme kelepçeleri cihazla birlikte verilmemiştir ve

ayrıca satın alınmalıdır.

Yağ filtresi destek çerçevesinin içine yerleştirilmiş olan polistiren çubuk

çıkarılmalıdır (bkz. a

şağıdaki çizim).

Üretici, bu kılavuzdaki talimatlara uyulmaması sonucu meydana gelebilecek

arızalardan, cihaz üzerindeki hasarlardan veya yangınlardan sorumlu tutulamaz.

INSTALLATION SHEET

The minimum distance between the support surface of the recipients on the cooking

device and the lowest part of the hood must not be less than 65 cm in case of electric

cookers and 75 cm for gas or combined cookers. If the installation instructions for the gas

cooker specify a greater distance, this must be taken into account.

Note on installation and use: It is advisable to contact a qualified technician for

installation. Before installing or using the hood, read this manual carefully; the

drawings are on the first pages.

To install, follow the numbers (1Ö2Ö3Ö.....) and relevant instructions.

The exhaust pipe and fixing clamps are not supplied and must be purchased

separately.

The polystyrene bar placed inside the grease filter support trim must be removed (see

illustration below).

The Manufacturer declines any liability for problems, fires or damage caused to the

appliance due to non-compliance with the instructions given in this manual.

5019 318 33231

Sadece bazı modellerde

bulunur

*Only on some models

5019 318 33231

SAFEGUARDING THE ENVIRONMENT

1. Packing

Packing materials are 100% recyclable and are marked with

the recycling symbol. Comply with local regulations for their

disposal. The packing materials (plastic bags, polystyrene

parts, etc.) are a potential source of danger and must be

kept out of the reach of children.

2. Product

This appliance is marked in compliance with European

Directive 2002/96/EC on Waste Electrical and Electronic

Equipment (WEEE).

By ensuring that this appliance is correctly scrapped, the

user can help prevent potentially harmful consequences for

the environment and the health of persons.

The symbol on the product or the accompanying

documentation indicates that it should not be treated as

domestic waste but must be taken to a suitable collection

centre for the recycling of electrical and electronic

equipment.

Disposal must be carried out in compliance with local

regulations on waste disposal.

For further information on the treatment, recovery and

recycling of this product, contact your competent local

office, the household waste collection service or the shop

where you purchased the appliance.

PRECAUTIONS AND GENERAL

RECOMMENDATIONS

IMPORTANT!

• The appliance is not intended for use by children

or persons with limited physical, sensory or

mental abilities or without experience and

knowledge of it, unless they are under the

supervision of or instructed in its use by a person

responsible for their safety.

• Children must be supervised so that they do not

play with the appliance.

1. Do not connect the appliance to the power supply until

installation has been completed. Always disconnect the

hood before any cleaning or maintenance, by

unplugging it or turning off the main switch in the

home.

2. Do not “flambé” food under the hood. Naked flames

could cause a fire.

3. Do not leave pans unattended when frying, since the

cooking oil could catch fire.

4. Regular cleaning and maintenance is essential for

correct hood operation and good performance.

Regularly clean all deposits from dirty surfaces.

Regularly remove and clean or change the filter. Do not

use flammable materials to duct the extracted air.

5. If the hood is used together with other appliances

operating on gas or other fuels, the negative pressure in

the room must not exceed 4Pa (4 x 10

-5

bar).

Therefore, make sure the room is adequately

ventilated.

6. The air extracted by the hood must not be removed

through the flue of the heating system or other

appliances that use gas or other fuels.

7. The room must be adequately ventilated when the

hood is used together with appliances operating on gas

or other fuels.

8. Make sure lamps are cold before touching them.

9. The discharge air must not be ducted in a flue used for

removing fumes produced by appliances operating on

gas or other fuels, but must have a separate outlet. All

national regulations on air discharge must be observed.

10. The hood is not a shelf, therefore do not overload or

place objects on it

Note: Always wear work gloves for all installation and

maintenance operations.

Electrical connection

The mains power supply must match the voltage given on

the appliance rating plate located inside the hood. If

provided with a plug, connect the hood to a power socket

complying with current regulations and located in an

accessible place. If it does not have a plug (direct connection

to the power supply) or if the socket is not in an accessible

place, fit a suitable double-pole switch that ensures

complete disconnection from the power supply in category

III overvoltage conditions, complying with the installation

rules.

IMPORTANT: Before reconnecting the hood circuit to

the power supply and checking correct operation,

always make sure the power cable is correctly fitted

and that it was NOT crushed in its housing during

installation.

Cleaning the hood

Warning! Failure to remove oil/grease (at least once a

month) could result in fire.

Use a soft cloth with a neutral detergent. Never use

abrasive substances or alcohol.

Before using the hood

To ensure best use of your hood, please read these

instructions carefully and keep them for future reference.

The packing materials (plastic bags, polystyrene parts, etc.)

are a potential source of danger and must be kept out of the

reach of children.

Make sure the hood was not damaged during transport.

Declaration of conformity

This product has been designed, manufactured and put on

the market in conformity with the following:

- safety objectives of “Low Voltage” Directive

2006/95/EC (which replaces 73/23/EEC as amended)

- protection requirements of “EMC” Directive

89/336/EEC amended by Directive 93/68/EEC.

Troubleshooting guide

The hood does not work:

• Is the plug properly inserted in the power socket?

• Is there a power failure?

The hood is not extracting enough:

• Is the right speed selected?

• Do the filters need cleaning or changing?

• Are the air outlets blocked?

The light does not work:

• Does the lamp need replacing?

• Is the lamp correctly fitted?

AFTER-SALES SERVICE

Before calling the After-Sales Service

1. Check to see if you can eliminate the problems on your

own (see “Troubleshooting Guide”).

2. Switch the hood off and then on again to check if the

problem has been eliminated.

3. If the problem persists, contact the After-Sales Service.

Specify:

• the type of problem,

• the product model given on the dataplate inside the

hood, visible on removing the grease filters.

• your full address,

• your telephone number and area code.

• the Service code (the number under the word SERVICE

on the dataplate inside the hood, behind the grease

filter).

If any repairs are necessary, contact an authorised Service

Centre (to ensure the use of original spare parts and correct

repair).

Failure to comply with these instructions can

compromise the safety and quality of the product.

5019 318 33231

1. Control panel.

2. Grease filters (1 or 2 pieces).

3. Lighting unit (on some models: halogen lamps).

4. Grease filter support trim.

Grease filter

Once a month wash the grease filter by hand or in a

dishwasher at low temperature and with quick cycle.

Important! The metal filter may become opaque

over time; this does not affect its filtering capacity.

To remove or wash the grease filter:

1. Disconnect the hood from the power supply.

2. Remove the dirty grease filter by pulling the handle

backwards and then downwards (Fig. 1).

3. After washing the grease filter proceed in reverse

order to refit it, making sure the entire extraction

surface is covered.

Replacing lamps

1. Disconnect the hood from the power supply.

2. Remove the grease filter (Fig. 1) and the grease

filter support trim (Fig. 2 - sequence a-b).

3. Remove the lamp to be replaced.

4. Only use 40 W max. E14 lamps.

For models with halogen lamps provide for 20 W

halogen lamps (GU5.3-12V-Ø 50 mm).

5. Refit the grease filter support trim.

Fitting or changing the carbon filter

(filter hood models only):

Change the carbon filter every four months.

It cannot be washed or regenerated.

Fitting or changing the carbon filter:

1. Disconnect the hood from the power supply.

2. Remove the grease filter (Fig. 1) and the grease

filter support trim (Fig. 2 - sequence a-b).

3. If the carbon filters are already fitted (one or two

filters, depending on the your model, covering the

motor protection grilles) and need changing, turn

the middle handle (Fig. 3 - c) anticlockwise until

they are released.

4. If the carbon filters are not fitted, fit them to cover

the motor protection grilles (two protection

grilles - two carbon filters, one protection grille -

one carbon filter), then turn the middle handle

(Fig. 3 - c) of the filters clockwise.

5. Refit the trim and the grease filter.

CONTROL PANEL

Light switch.

The light key has two positions

(lights OFF - lights ON).

To switch on the lights: move the key to the right.

Speed selector switch.

The motor key has several positions for

controlling extraction speeds according to the

amount of steam and fumes.

To increase the extraction power (speed): move

the key to the right.

Fig. 3

Fig. 1

Fig. 2

Models with halogen lamps

PRODUCT SHEET

5019 318 33231

The hood is designed for use in “Extractor version” or

in “Filter version”

Extractor version

Fumes are extracted and expelled to the outside

through an exhaust pipe (not supplied) fixed to the

hood coupling ring.

Depending on the exhaust pipe purchased, provide

for suitable fixing to the coupling ring.

Important: If already installed, remove the carbon

filter/s.

Filter version

Air is filtered through a carbon filter/s and recycled

into the surrounding environment.

Important: Ensure that air recirculation is facilitated

(carefully follow the instructions given in the

installation handbook)

Important! If the hood does not have a carbon filter/

s, it/they must be ordered and fitted before use.

The hood is provided with hardware (e.g. screws and/

or plugs) suitable for most walls/ceilings. However, it

is necessary to contact a qualified technician to ensure

suitability according to the type of wall/ceiling. The

wall/ceiling must be strong enough to take the weight

of the hood.

Very heavy product; hood handling and

installation must be carried out by at least two

persons.

Whirlpool AKR 605 IX Program Chart

Marka: Whirlpool

Modeli: AKR 605 IX

Kategori: Ocak davlumbazları

Tip: Program Chart

PDF''yi indir

rapor

diğer dillerde

English: Whirlpool AKR 605 IX

Whirlpool AKR 605 IX Program Chart

Whirlpool AKR 605 IX Program Chart

diğer dillerde

İlgili makaleler