8
CAUTION!
Not observance can result in
damage to possessions
●
Always plug the appliance to the mains (AC only) with
voltage corresponding to that indicated on the rating
plate.
●
Always place the kettle on a stable, smooth, at
surface; the power cord must not hang loosely off the
edge of a table (or any other work surface) or touch
a heated surface.
●
Do not remove the plug from the mains by pulling by
the cord.
●
This appliance is intended for indoor use only.
●
The kettle can only be operated with the original power
base (each base is type-specic).
●
Use the kettle for boiling water only.
●
Do not open the lid right after the water has boiled –
steam might condense and appear on the exterior of
the kettle.
●
Do not place the kettle on or near hot objects.
●
Do not immerse the kettle or the power base in water
when lling or washing the electric kettle.
●
If water gets into any electric elements inside the kettle
or onto the base, carefully dry these elements before
plugging the kettle to the mains.
●
Do not operate the kettle when empty.
●
Do not use the kettle with the lid open – the automatic
shut off will not work then.
●
Do not use any abrasive cleaning agents – such as
emulsions, creams, pastes, etc. – for cleaning the
kettle body. They might remove graphic information
symbols, such as scales, marks, warning signs, etc.
●
The appliance is not intended to be operated by means
of an external timer or separate remote-control system.
Kettle elements
A
1
Spout
2
Kettle body
3
Water level indicator
4
360° swivel base
5
Lid release button
6
On/off switch (0-I with power indicator)
7
Handle
8
Anti-deposit lter
9
Cord storage
Preparing the kettle for operation
Before rst use, wash the kettle inside (for
washing instructions see the “Cleaning and
maintenance” section), ll it with water up to the
“max” level, boil water four times (each time use
fresh water) and wash the kettle inside again.
Operating the kettle
B
1
Press the lid button (5) – the kettle lid will open.
2
Place the lter (8) in the kettle (if it is not in place).
3
Fill the kettle with the desired amount of water (the level
is visible on the indicator (3)).
Do not boil the water if it is below the minimum
level or beyond the maximum level on the
indicator (3).
4
Close the lid.
5
Place the kettle on the base (4).
6
Plug the kettle to a socket provided with an earth pin.
7
Turn the kettle on by pressing the switch (6) – the power
indicator light will come on.
8
After the water is boiled, the kettle will switch off
automatically, the lever switch will return to its starting
position and the power indicator will go off.
If you plan to use the kettle again soon, it is not necessary to
remove the plug from the mains.
Make sure that the maximum kettle capacity
is not exceeded when the kettle is lled with
water.
In the event that an empty kettle is switched
on, it will be switched off automatically by
a thermal device.
To switch on the kettle after it has cooled down
(about 15 min), remove it from the base, ll with
water, replace on the base and switch on by
pressing the switch (6). The cooling down of
the kettle can be accelerated by pouring cold
water into the kettle.
SUGGESTION
Information on the product and
suggestions for its use
●
This appliance is intended for domestic use only.
In case it is used for food business purposes, the
warranty conditions shall change.
●
Do not use the kettle without the lter.
Technical data
The technical parameters are given on the rating plate of the
product.
1.7 litre capacity.