17 ENGLISH
A set of long nozzles help clean dust out of small holes
and narrow spots. Nozzle lengths can be arranged
according to your requirements.
Nozzle 13 Long nozzle R Long nozzle F
Insert the long nozzle R through the air hole of the
nozzle 13 from back to front. Pass it though until the nozzle
13 secures in place at the rear end of the long nozzle R.
Nozzle 13 Long nozzle R
Place the long nozzle F over the front end of the
long nozzle R. Hand screw the long nozzle F until you
is secured with a click.
Long nozzle F Long nozzle R
the locking notches on the lock sleeve of the tool, then
locks in place with a click.
Locking notch Lock
sleeve Nozzle 13 Long nozzle R
Long nozzle F
NOTE: Use the long nozzle R only to have a shorter
operating range. Use both the long nozzle R and F to
allow a wider operating range.
To remove the long nozzles, detach the nozzle 13
from the lock sleeve of the tool, and then disassemble
the long nozzles.
NOTICE:
Handling the air vent hose complete assembled
into the tool may cause the tool to stand unstable
resulting in it falling over.
with the locking notches on the lock sleeve of the air vent
into the lock sleeve until it locks in place with a click.
Pinch valve nozzle
Locking notches Lock sleeve Air
vent hose complete
Optional rubber attachments require to be placed over
the nozzle. Be careful not to attach rubber attachments
directly to the air vent hose complete.
the locking notches on the lock sleeve of the air vent
sleeve until it locks in place with a click.
ii Place a rubber attachment over the nozzle head
by pushing and hand screwing it in place.
Rubber attachments Nozzle 13 Air
vent hose complete
NOTICE:
NOTE: While the polished surfaces of the nozzle end
remain visible out of the lock sleeve, the nozzle is
being inappropriately placed.
Reassemble the nozzle in a correct position so the
polished surfaces of the nozzle end become invisi-
ble under the lock sleeve.
Polished surfaces Lock sleeve
Turn the dust cap on the suction inlet at the rear of
the housing counterclockwise to take the dust cap out of the
housing. Two locking tabs on the dust cap can be disengaged
by aligning them with the guide grooves on the housing.
Dust cap Locking tabs Suction inlet
Guide grooves
Attach the end of the air vent hose complete to
the suction inlet, aligning the two locking tabs on the
air vent hose complete with the guide grooves on the
hose complete clockwise to secure it in place.
Air vent hose complete
Suction inlet Locking tabs Guide grooves
follow the installation steps in reverse.
NOTICE:
for restricting dust intake into the motor under dusty
working conditions.
Turn the dust cap on the suction inlet at the rear of
the housing counterclockwise to take the dust cap out
of the housing. Two locking tabs on the dust cap can be
disengaged by aligning them with the guide grooves on
the housing.
Dust cap Locking tabs Suction inlet
Guide grooves
suction inlet, aligning the two locking tabs on the optional
Locking
tabs Suction inlet Guide grooves
NOTICE:
-
NOTICE: