16
Common faults Common faults
The machine cannot be turned on Check if the plug has been plugged in properly.
Check if the juicing has been fitted properly.
The machine cannot be started,
and the indicator lamp flashes
Check if the juicing or jam bowl has been fitted
properly, and check if the safety lid is properly
aligned.
The machine stopped suddenly
during operation, and alarm is
sounded
Is the machine is clogged from excessive feeding
(too many pieces or pieces too large)?
Put the machine into “Reverse” mode and let it run
for 5 seconds.
Has the machine entered its safety mode after
working continuously for more than 20 minutes?
Solution: Allow the machine to rest for 30 minutes,
then try again.
If you are unable to restart the machine, get in touch
with our customer service.
The auger has been scratched The gap between the auger and screen is very small;
avoid running an empty machine as far as possible.
Very little juice is extracted Water content varies between different fruits and
vegetables.
Fruits and vegetables also produce less juice when
they lose their freshness.
When juicing hard fruits and vegetables, check that
the adjustment lever is in the “Open” position
There is a lot of water in the pulp When juicing soft fruits and vegetables, check that
the adjustment lever is in the “Closed” position.
The screen wiper basket does not
rotate during operation
Check if the gear at the base of the juicing bowl has
detached.
The juicing bowl shakes slightly
when the machine is turned on
Slight shaking of the juicing bowl during operation
is normal.
The safety lid cannot be opened
after juicing
There could be too much residual pulp in the
machine, or the fruits being juiced may have
hard pits, etc. Turn the switch knob to the “Reverse”
position and allow the machine to run in the reverse
mode for a few cycles, and then try again.
If you are unable to resolve the problem after trying
the above, get in touch with our customer service.