PRODUCT SHEET
GB
Freezer compartment temperature adjustment
The appliance is normally factory set for optimum operation at a temperature of -18°C. To alter the
internal temperature between -16°C and -24°C, proceed as follows:
• Press button E once to adjust the internal temperature: the digital display shows the temperature
previously set.
• Each time the button is pressed, the temperature setting is changed by 1°C: the value (between -16°C
and -24°C) blinks cyclically on the display.
• Approximately 5 seconds after the button has been pressed for the last time, the set temperature is
stored, the display stops flashing and the current internal temperature is shown on the display.
• The "6th Sense"/"Dynamic Intelligence" function is automatically activated due to door opening and
when small amounts of fresh food are placed in the freezer. The duration of the "6th Sense"/"Dynamic
Intelligence" function varies depending on the quantity of food loaded in the freezer and ambient
temperature. When optimal operating conditions have been restored the function deactivates
automatically and no operation is required.
Note: The digital display shows internal temperature values between +10°C and -24°C. In the event of a
power failure, selected functions remain stored in the memory.
Fast freezing
The fast freeze function switches off automatically when freezing is complete.
Note: The temperature alarm may activate if the door is left open for a prolonged period of time or
following the introduction of fresh food in the freezer compartment; this temporary rise in temperature
does not affect the storage of already frozen food in any way.
Defrosting (for No Frost models no operation is required)
This appliance defrost automatically according to usage and ambient humidity conditions.
Follow the steps detailed in "Switching on the appliance".
For not No Frost models, follow step 1-6:
1. Press the freezer on/off button D.
2. Unplug the appliance or switch off at the main
switch.
3. Fit the drain in place (see figure).
4. Follow the instructions given in the instructions
booklet.
5. Plug in the appliance once again.
6. Press the freezer on/off button D.
An illuminated dot appears on the digital display.
Follow the steps detailed in "Switching on the
appliance".
Alarm signals
Signalling Cause Solution
Door open alarm The acoustic alarm is
activated
The door has been left open for
more than 1 minute
Close the door
Temperature
alarm
The acoustic alarm and red
led C are activated
The internal temperature is
above -12°C
Press button G; wait for
the temperature to fall
below -12°C again
Temperature
sensor alarm
The acoustic alarm is
activated and the display shows
"SF"
Temperature sensor fault Contact After-sales
service
Prolonged power
failure alarm
The acoustic alarm and red led
C are activated; the display
flashes, indicating the highest
temperature reached following
the power failure
Prolonged lack of power supply,
causing the internal temperature
to rise to very high values at
which correct food storage
cannot be guaranteed
Press button G; the
display now indicates the
current internal
temperture